Use the Fillet Command

The Fillet command is used to draw a fillet between two elements. The elements can be arcs, lines, circles, ellipses, or curves.

In this lesson, you will draw a box and then use the Fillet command on the Draw toolbar to place a fillet at each corner.

Click the Show Me   button on the SmartSketch Learning Center toolbar to view a demonstration of how to perform the tasks in this lesson.

1. On the Main toolbar, click the Zoom Area button.
2. Click the upper left of the inside wall of the room on the right and select the lower right corner of the room.
3. On the Draw toolbar, click the Line/Arc Continuous button. 
4. On the Line ribbon bar, click in the Line Color button, and select Red to change the line color.
5. Draw a 20-inch horizontal line in the open space.
6. Move the mouse cursor down to draw an 18-inch vertical line.
7. Draw two more lines to complete the box.
8. On the Draw toolbar, click the Fillet button. 
9. On the Fillet ribbon bar in the Radius box, type 4 inches and press the Enter key.
10. Click each corner of the box.